Construction start with an 18 inch piece of the galvanized steel pipe.
Diy pull up bar.
Thread the pipe into one end of the galvanized 90 degree elbow.
Thread one of the flanges onto the opposite.
In general i recommend.
Make each hole big enough to hold a 5 us gal 19 l plastic bucket.
How to make a pull up bar.
Using the 48 inch piece of galvanized steel pipe and working with one set of the piece finished in the step above.
Space the holes 4 ft 1 2 m apart or the length of the steel bar you plan on using for your pull up bar.
Glue and screw flanges to pipe.
Set buckets inside the holes to test their size.
Making a diy pull up bar in 5 simple steps step 1.
Supplies needed one 2 4 or other scrap wood one 1 inch x 36 inch galvanized pipe two 1 inch galvanized cap fittings tennis grip tape optional wood screws 1 1 2 inch spade drill bit power drill.